Channel Master CM-6001 Spezifikationen PDF herunterladen (Seite 56)

Channel Master Operation Manual

page 50 RD Instruments

save it in the Channel Master. This procedure assumes that you will be us-

ing the program BBTalk that is supplied by RD Instruments.

a. Connect the Channel Master to the computer and apply power (see

“Setup the Channel Master,” page 10).

b. Start the BBTalk program and establish communications with the

Channel Master. Wakeup the Channel Master by sending a break sig-

nal with the End key.

c. Send the command CR1 to place the Channel Master in the factory de-

fault setup.

d. Send the CB-command that selects the baud rate you wish. The fol-

lowing are the typical CB-command settings for different baud rates

with no parity and 1 stop bit:

Table 9: Baud Rate

BAUD RATE CB-command

1200 CB111

2400 CB211

4800 CB311

9600 CB411 (Default)

19200 CB511

38400 CB611

57600 CB711

115200 CB811

e. In BBTalk, press F5 and change the settings to match your CB com-

mand settings. Press OK to exit the communication setup screen.

f. Send the command CK to save the new baud rate setting.

g. Click File, Close to exit the terminal window.

The Channel Master is now set for the new baud rate. The baud rate will

stay at this setting until you change it back with the CB-command.

Note If you send a BREAK before changing the external device’s

communication parameters, the Channel Master returns to the

communication parameters stored in non-volatile memory

(user settings).

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 137 138

Keine Kommentare

Channel Master CM-6001 Spezifikationen Seite 56